Auto robot stacking system

Cutter, heavy program-controlled pneumatic

Cutter, QT220+QP220D

Hammer Crusher

The clay bar machine after forming is sent to the blank cutter, which is cut into the required size of the blank. Then it is sent to the kiln car by the blank distributor, the blank conveyor, the automatic blank code machine, and sent to the blank shop by the hydraulic ferrying machine for storage.The brick dried by air is sent to the drying kiln by the hydraulic ferrying crane.

Since the drying and roasting are not separated, the dried blank body does not need to go out of the drying section but directly into the roasting section, so the heat loss is less and the utilization rate is higher than that of the parallel type.